Nube-iO Rubix Platform: LoRa Network Configuration

Rubix Platform: LoRa Network Configuration

This article details how to configure the LoRa Network.  This will allow Nube-iO controllers, that are equipped with LoRa (RAW) radio cards, to act as Wireless LoRa (RAW) Gateways to receive data from Wireless LoRa Sensors.  

Preparation

  1. Rubix Platform: Navigation
  2. Rubix IO: Configuring Modbus Communications Parameters
  3. Rubix Platform: Adding and Editing Wireless LoRa Droplet Sensors
  4. Rubix Platform: Adding and Editing Wireless Microedge Sensors

Configuring LoRa Serial Network Settings 

Select 'Driver > LoRa Network' from the Rubix Platform Sidebar;  Next select the `SERIAL NETWORKS` tab.  Here you will see the LoRa Network settings.

Configure `SERIAL NETWORKS` Settings

It is essential that the `SERIAL NETWORKS` settings are correctly configured for the LoRa Gateway to operate.  The `SERIAL NETWORKS` settings should be configured with values as follows:
Port: /dev/ttyAMA0
Baud Rate: 38400
Stop Bits: 1
Parity: N
Byte Size: 8
Timeout: 5
The `SERIAL NETWORKS` settings should match the image below:

  1. LoRa Wireless: Installation Best Practices

    • Related Articles

    • Rubix Platform: Adding and Editing Wireless LoRa Droplet Sensors

      To recieve data from Nube-iO Droplet Sensors they must be added to Rubix Platform.   To begin ensure that your Droplet sensors have been configured correctly; see Droplet Installation and Setup.  Droplet Sensors operate using LoRa wireless ...

    • Rubix Platform: Adding and Editing Wireless Microedge Sensors

      To receive data from MicroEdge sensors they must be added to Rubix Platform.   To begin ensure that your MicroEdge sensors have been configured correctly; see MicroEdge Installation and Setup.  MicroEdge Sensors operate using LoRa wireless ...

    • Rubix Platform: Mapping LoRa Points to Rubix Points

      This article describes the process of mapping LoRa Points to Rubix Points.  This is done in order to store history logs of the LoRa sensor data. Preparation Rubix Platform: Navigation Rubix Platform: Adding and Editing Wireless LoRa Droplet Sensors ...

    • Rubix Platform: Modbus Network Configuration

      This article explains how to configure the Modbus Network within Rubix Platform.  This will allow us the send and receive Modbus data from connected Modbus devices. Ensure Modbus Service is Running It is important to ensure that the Modbus Service is ...

    • Application Guide: LoRa Sensor Data to Rubix Wires

      This Appication Guide is intended to teach the complete process of getting wireless LoRa (RAW) sensor data from Droplet or MicroEdge sensors into Rubix Wires for use in custom control logic/programs.   Preparation To complete this Application Guide ...